CR-5 Setup Instructions
- Important – These instructions are for SimHub 8.1 and above. If you’re running SimHub 8.0 and below follow these instructions instead.
Firstly you need to download the drivers to make the dashboard work. The zip file with all of the drivers and profiles necessary for this guide can be found here – CR5.zip
Now unzip/extract the contents of the folder, and run the VOCOREScreenSetup.exe file to install the screen driver. Next open the Arduino_driver folder and run the SETUP.EXE file to install the Arduino Nano driver that controls the LEDs.
Now that the drivers are installed, download and install SimHub 8.1 or later from www.simhubdash.com if you don’t already have it. Once installed, open SimHub and go to the Devices page on the left side. Click Import Device from File and choose the CR-5.shdevice file from the zip you downloaded earlier.
Here you can select the Dashboard you wish to display while both in-game and when the dash is idle. Now go back to the Games screen on the left, find the game you want to start and follow any instructions for configuring that game’s telemetry. You can now start the game and you will see the dashboard appear on the CR-5 screen.
Once you’ve made sure that works, go back into SimHub and go to the Arduino section on the left, then My Hardware at the top and select “Single Arduino”. Wait until the CR-5 information appears in the “Detected Hardware box”, then go to RGB Leds at the top. Here you can either import the supplied profile using the Profiles Manager (CR5.ledsprofile) or create your own. The supplied profile should give you a good starting point. To import the profile, click on Profiles Manager, click on the import icon and select the file downloaded earlier.
Here you can configure the LEDs on your device, and they are set up like this – LEDs 1-2 are the left flag lights, LEDs 3-18 are the RPM/Rev LEDs, and LEDs 19-20 are the right flag lights. SimHub comes with some default setups for RPMs and lights, but you will need to modify them to take advantage of the side flags on the CR-5. Below is how to configure the Yellow flag to show on both sides :
And here’s how to configure the RPMs
And that’s it for basic configuration. The sky is the limit with SimHub, you can design your own dashboard or download new ones that others have designed, and you can configure the LEDs to do a multitude of things to suit your needs. If you have any questions, feel free to contact us through Etsy or email through the Contact page here.